|
|
 |
Home>Tools>Mr.SSP (Syunkan Setchaku Putty) |
 |
|
|
|
|
|
-HG liquid : 10g x 2pcs.
-HG powder : 4.5g
-Softener : 2g
-Measuring spoon : 1pc
-Spatula : 1pc
-Sheets : 3 sheets
-Needle : 1pc
-Instructions :(1 Sheet)
[Features]
Easily shapeable just like plastic material
Powerful bonding (adhesion) and putty filling can be performed simultaneously in a short time.
No slumping occurs after hardening, and almost no chipping or cracks appear on carved areas.
[Usage]
Adhesion to a wide range of model parts in general including plastic models, garage kits, figures and various small-scale models,
covering up joint lines between parts,putty filling,build up modeling processes.
[Usage method]
1.tape the attached sheet to a flat surface.
※These Sheets can be used several times. If no more sheets are available, a plastic bag or craft tape for packing can be used instead.
2.Scoop up HG powder with a measuring spoon and level it off using a spatula.
3. Place the HG powder on the sheet, and place the necessary number of drops of HG liquid nearby avoiding contact with powder.
※if the HG liquid is dropped directly on the HG powder, hardening will occur quickly and your working time will be shortened. Check the
amount of HG liquid and softender you require by referring to the "Guideline for mixing" mentioned above.
4.After placing the powder and HG liquid,mix them quickly with a spatula till they blend uniformly.
After the putty has been mixed properly, apply it to the surface of the joint or the area to be filled in with a spatula.
※It's convenient to use the other side of the spatula when applying it to areas of detail.
4.Remove stains from the surface to be bonded or th be built up beforehand.
Finish build up work before putty starts to harden.
|
|
